CAUTION:
Do not over tighten fasteners.
Solar Lamp Assembly
1.
(SEE FIGURE 2)
Attach light top (A) to plastic
len (B). Turn light top (A) clockwise to lock.
2. Carefully push stake (C) into bottom of solar
light plastic lens (B).
3. Insert ground spike (D) into of bottom stake (C).
CAUTION:
In compacted, clay or hard soils,
moisten the ground with water before
inserting the ground stake to avoid breakage.
4. Holding the light by the center section,
carefully push stake into the soil. DO NOT
push down on the light top, doing so
may cause damage.
5. Reference section entitled "Operating Solar
Light" to charge rechargeable batteries.
Battery Replacement
NOTE:
Battery is located on the underside
of light top.
1.
(SEE FIGURE 3)
Turn solar light top over.
Remove solar light top by turn counterclockwise.
2. Place the On/Off switch to the "OFF" position.
3. Remove the battery cover, then remove and
replace old batteries with a new battery
of the same rating.
4. Install new battery in proper direction,
reference polarity (+/-) markings inside
battery compartment for correct placement.
6. Refer to section entitled "Charging
Rechargeable Batteries" to restore solar
lights to full operation.
B
A
D
C
Figure 2
Figure 3
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
ASSEMBLY INSTRUCTIONS
D
A
B
C
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ON/OFF
Switch
Battery
Cover
Battery
Charging Rechargeable Batteries
NOTE: The rechargeable batteries are
preinstalled from the factory.
Before
operating, the batteries need to be fully
charged. The batteries require at least
8-hours of full sunlight to charge.
1.
(SEE FIGURE 1)
Turn solar light top over.
Place the On/Off switch to the "OFF" position.
2. Place the solar light in full sun, away from
streetlights or other light sources where it
will receive direct sunlight for at least
8 hours per day.
3. After batteries are fully charged, place light switch to the “ON” position. The light will
automatically turn on at dusk and off at dawn.
NOTE:
The number of hours light is illuminated is directly proportional to the number of hours
of sunlight it receives. The solar panels cannot recharge the batteries if light is obstructed.
Care Instructions
1. Clean any dirt and debris from the solar panels. Panels cannot recharge if light is obstructed.
Use a soft cloth to clean the panels. Do not use abrasive or chemicals that might scratch or
destroy the UV coating on solar panels.
2. In a region where the light assembly is covered with snow for an extended period of time
the batteries will require recharge for at least 8 hours.
OPERATING SOLAR LIGHT
Figure 1
1
Parts Detail
Recycling
Please dispose of batteries properly. Consult you local telephone listings or a battery
recycling center in your area.
2
LED
On / Off Switch
Protect Ni-Cd batteries
against heat and fire
risk of explosion
Recycling
Do not dispose of
Ni-Cd batteries in
household waste
Do not throw
Ni-Cd batteries
into water!
Ambient temperature
maximal 40 C (105 F)
Solar
Light Top
A
Solar Light Top
6
B
Fluted Plastic Lens
6
C Stake
6
D Ground
Spike
6