PARTS LIST
PART #
DESCRIPTION
QUANTITY
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER.
CONTACT CUSTOMER SERVICE AT
1-888-424-3354
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
A
Table Top
1
B
Table Leg
4
C
Leg Connector Ring
1
D
Bumper
4
E
Bolt
8
F
Plastic Umbrella Cap
1
1.
(SEE FIGURE 1)
Insert bumper (D) into
previously drilled holes at top of each leg (B).
CAUTION: Do not
place table top on a hard
surface during assembly. Possible damage
to table top can occur.
2.
(SEE FIGURE 2)
Place table top (A) upside
down on a flat non-scratch surface.
3. With bumper (D) installed, slide each leg (B)
into end cap leg fittings as show in diagram.
NOTE:
Make sure bumper (D) on the leg stays
in place between leg and glass top.
4. Place leg connector ring (C) between legs and
loosely attach ring using bolts (E).
5. Check alignment of all legs, and correct,
if necessary before tightening bolts.
6. Gradually tighten all bolts, moving from one
leg, then the next until all legs firmly attached.
7. Place table right side up and install plastic
umbrella cap inside center hole of table.
NOTE:
This product is intended for residential, non-commercial use.
A
B
C
D
E
Figure 1
F
G
D
B
B
A
E
C
1
2
Figure 2
F
