ASSEMBLY INSTRUCTIONS
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER
. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
A
B
C
E
D
G
F
H
I
FIGURE 1
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A
1
Glass Table Top
B
C
1
Connector Ring
D
4
Table Leg
E
12
Bolt, 6mm x 30
F
12
Plastic Umbrella Cap
Flat Washer
Plastic Bolt Caps
G
12
12
Allen
®
Wrench
H
Touch Up Paint (with table leg)
1
I
1
A
B
C
D
D
F
F
D
F
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
1.
(SEE FIGURE 1)
Unpack all parts and remove packing material on non-scratching surface.
2. Place table top (A) upside down on a flat, non-abrasive surface.
3. Attach each table leg (C) to edge of the table top (A) with bolt (D) and lock washer (F),
finger tighten only.
4. Attach each leg (C) to connector ring (B) using bolt (D) and lock washer (F).
NOTE:
Insert each bolt (D) from the inside of connector
ring into table leg and finger tighten only.
5. Secure connector ring to table legs by tightening each bolt (D) two revolutions at a time,
alternating between bolts in a cross corner fashion (X).
6. Once center connector ring is in position, tighten table top bolts (D) using Allen
®
wrench (G).
Next, tighten connector ring bolts (D) using Allen
®
wrench (G).
7. Carefully turn the table frame assembly to the upright position onto it legs and
securely tighten all bolts.
8. Place plastic bolt caps (H) over each bolt (D). Place plastic umbrella cap (E) over the
umbrella hole in the table top (A).
Caution:
Placing table top and legs on a hard surface may scratch
table glass and damage table rim and legs.
