A
Table Top
1
B
Table Leg
2
C
Wing Nut
4
1.
(SEE FIGURE 1)
Place table top (A) upside down on a non-scratching surface
such as a piece of carpet, blanket or large towel.
2. Turn one of the two-leg assemblies (B) upside down so that the holes at the
top of the legs slide onto the threaded studs mounted underneath the
table top (A). Then do the same with other leg assembly. The center support
holes should fit flush together.
3. Screw 1 wing nut (C) onto each threaded stud and tighten securely.
4. Have someone help you turn the table right side up.
5. All four legs should sit flat. If the table rocks, you have the leg assemblies
mounted in reverse order. If so, repeat steps 1 - 3 reversing the placement
order of the legs.
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A
B
C
ASSEMBLY INSTRUCTIONS
Figure 1
CAUTION:
Do not over tighten fasteners.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
C
B
A
