PARTS LIST
PART #
DESCRIPTION
QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
A Table
Top
1
B Table
Leg
4
C Center
Brace
2
D Bolt
8
E
Lock Washer
8
F
Plastic Bolt Cover
8
G Hex
Wrench
1
Figure 1
Parts Detail
CAUTION:
Do not over tighten fasteners.
Install Table Legs
1.
(SEE FIGURE 1)
Place table top (A) upside down on flat non-scratch surface.
2. Turn one table leg (B) upside down and insert leg into end cap fittings as shown.
Repeat for three remaining table legs.
Install Upper Center Brace
1. Align one center brace (C) with upper mounting hole of the four table legs.
2. Place lock washer (E) onto bolt (D) and insert bolt with washer into upper mounting hole
of one table leg as shown.
3. Next, thread bolt through center brace (C). Using hex wrench (G), loosely tighten bolts.
Repeat step 2 and 3 for four remaining legs.
NOTE:
Do not tighten bolts until all three legs are secure.
Install Lower Center Brace
1. Align remaining center brace (C) with lower mounting hole of the four table legs.
2. Place lock washer (E) onto bolt (D) and insert bolt with washer into lower mounting hole
of one table leg as shown.
3. Next, thread bolt through center brace (C). Using hex wrench (G), loosely tighten bolts.
Repeat step 2 and 3 for three remaining legs.
4. With both center braces (C) in place, tighten each bolt a few revolutions at a time,
alternating between bolts in a cross corner "X" fashion.
B
A
D
E
F
G
C
1
2
Table Leg Upper
Mounting Hole
Table Leg Lower
Mounting Hole
NOTE:
Tightening every other bolt or in a cross fashion will ensure your table is level by
placing equal pressure on each joining bolt.
5. Cover all bolts with plastic bolt cap (F).
Your table is now ready to use.
C
D
E
F
B
A
C
D
E
F
D
E
F
D
E
F
D E
F
D
E
F
D
E
F
D E
F
(4 places)
