1
A
A
A
C
C
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A Table
Top
1
B Table
Legs
6
C
Leg Connector Bracket
1
D
Table Support Bracket
1
E
Rubber Table Top Bumper
6
F Flat
Washer
12
G
Hex Bolts M6x25
12
H Bolt
Cap
12
I Nut
Cap
12
J Nut
12
K Wrench
1
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
Parts Detail
NOTE:
This product is intended for residential, non-commercial use.
B
B
B
B
D
D
E
E
F
F
F
G
G
H
H
I
I
J
J
K
K
K
ASSEMBLY INSTRUCTIONS
CAUTION:
Do not over tighten fasteners.
Figure 1
Figure 2
Figure 3
2
1. (FIGURE 1)
Insert the rubber table top
bumpers (E) into the holes located on the
top of the table legs (B).
2.
(FIGURE 2)
Place the table top (A) upside down
on a flat non-scratch surface. Insert table
legs (B) into leg fittings of the table top (A).
3.
(FIGURE 3)
Place leg connector bracket (C)
between table legs (B) and secure with hex
bolts (G) and flat washers (F) using hex
wrench (K) on the outside of the table leg.
Secure with nuts (J) and flat washers (F) on
the inside on the table legs. Do not tighten fully.
4. Repeat step 3 using table support bracket (D).
5. Turn table upright and tighten all bolts and nuts
in a cross “X” fashion. Place bolt caps (H) and
nut caps (I) on bolts and nuts.
