ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
E
H
G
K
D
2
1
A Large
Basin
1
B Medium
Basin
1
C Small
Basin
1
D Post
1
E Pedestal
1
F Base
1
G Fountain
Cap
1
H First
Tier
1
I Second
Tier
1
J Rubber
Stopper
1
K Pump
Assembly
1
L Screws
3
L
J
F
CAUTION:
Do not over tighten fasteners.
2.
(SEE FIGURE 2)
Pass Pump Assembly
Power Cord (K) through the hole in the
Large Basin (A). Pull through until the
Rubber Stopper (J) fixed to the Pump
Assembly Power Cord can be pushed into
the hole to form a water-tight seal.
3. Assemble Pedestal and Post (D) to Base, (F)
passing Pump Assembly Power Cord
through each item as required.
1.
(SEE FIGURE 1)
Secure Pump Assembly (K) to
Large Basin (A) using the three screws (L).
4.
(SEE FIGURE 3)
Push the cascade tiers and
Medium and Small Basins onto the metal
pump spout. Screw the Fountain Cap (G)
onto pump Spout.
5. Place bath on a level surface and fill with
clean fresh water.
6. Connect the Pump Assembly Power Cord to
the nearest indoor AC Power Outlet.
7.
Care:
The bath will require a minimum of
1-gallon of water to function correctly.
Clean the pump with a soft bristled brush
and clean water. Flush through using a
garden hose. The flow rate of the pump can
be adjusted using the small lever at its
base. During hot weather the water can
evaporate quickly causing the pump to run
"dry" resulting in possible damage/failure
to the unit. Keep the large fountain basin
full and do not leave it running unattended.
If you notice the pump's performance
deteriorating, check for blockages and or
clean the pump.
The fountain should be placed on level
ground. Clean the pump and bath regularly.
Do not allow water to become overgrown
with algae. Do not place aquatic plants in
the fountain. Do not place pump in any
liquid other than clean water. Do not use in
water above 86 degrees Fahrenheit. Do not
lift, pull or carry the pump by the power
cord. Do not plug the transformer into an
outside socket. Do not run the pump "dry".
Figure 3
Figure 2
K
B
K
A
L
L
A
B
C
I
Parts Detail List
J
Pump Assembly
Power cord
H
G
A
B
C
I
Figure 1
Metal Spout
Metal Spout
