ASSEMBLY INSTRUCTIONS
2
3
A Base
Pedestal
1
B Large
Basin
1
C Center
Pedestal
1
D Small
Basin
1
E Electric
Pump
1
PARTS & HARDWARE LIST
PART #
PART #
DESCRIPTION
QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
D
C
Parts Detail
A
E
B
Figure 2
ASSEMBLY INSTRUCTIONS
1.
(SEE FIGURE 1)
Place the base pedestal (A) on
flat, level surface. Put the large basin (B) on the
base pedestal (A) aligning the tabs of the basin
with the notches in the top of the base pedestal
(A). Turn the large basin counter clockwise to
lock into place. Put the electric pump (E) into
the center ring in the bottom of large basin (B)
beside the PVC tube. Place the power cord of
the pump (E) through the PVC tube, the pedestal
base (A) and out the bottom of the base
as shown.
B
B
A
Figure 1
Basin Tab
Power Cord
Power Cord
Power Cord
E
Base Notch
AMP Load
Volts Extension Cord Length
120V
25'
50' 100'
150'
AWG
1-5
18
16
16
14
6-10
18
16
14
12
10-12
14
14
14
12
12-16
14
12
Not recommended
Table 1. Minimum Recommended Extension Cord Gauge (AWG) Chart
Outdoor Use Extension Cords
1. When product is used outdoors, use only
extension cords marked for outdoor use.
2. Use only UL listed extension cords. Never use
damaged or altered extension cords.
3. Follow extension cord manufacturer safety
instruction.
Extension Cords
1. Make sure your extension cord is in good condition.
2. When using extension cords, be sure to use one heavy enough to carry the current your product
requires. An undersized cord will cause a drop in line voltage resulting in power loss and
overheating. Reference Table 1 at the bottom of the page for the correct size to use depending
on cord length and nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.
Adjust Speed of Water Flow
1. Unplug pump (E) from AC power outlet.
2. Move adjustment switch on pump (E)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check electric pump (E),
and the clear tubing for clogs.
NOTE:
Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
3.
(SEE FIGURE 3)
Connect the tube of the small
basin (D) to the spout on the electric pump (E).
Connect the small basin (D) and center
pedestal (C) aligning the tabs of the basin with
the notches in the top of the base. Turn the
center pedestal (C) clockwise to lock into place.
4.
(SEE FIGURE 3)
Fill the fountain basin (B) with
water; if possible use distilled water to
fill
fountain.
5. Plug power cord into properly grounded
120V
AC
outlet.
2.
(SEE FIGURE 2)
Put the center pedestal (C) on
the large basin (B).
C
Tubing
Figure 3
E
E
D
C
