ELECTRICAL SAFETY INSTRUCTIONS
WARNING!
ELECTRICAL SHOCK.
Read and understand all instructions. Failure to follow all
instructions listed below, may result in electrical shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS.
Grounding Instructions
This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has
been installed and grounded in accordance with all local, state or federal codes and ordinances.
DANGER:
IMPROPER INSTALLATION OF THE GROUNDING PLUG CAN RESULT IN A RISK OF
ELECTRICAL SHOCK.
Check with a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt as to whether the product is properly grounded. Do not
modify the plug provided; if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Do not use any type of adapter with this product.
PARTS & HARDWARE LIST
PART #
PART #
DESCRIPTION
QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
B
C
D
A
1
2
Parts Detail
AMP Load
Volts Extension Cord Length
120V
25'
50'
100'
150'
AWG
1-5
18
16
16
14
6-10
18
16
14
12
10-12
14
14
14
12
12-16
14
12
Not recommended
Table 1. Minimum Recommended Extension Cord Gauge (AWG) Chart
Outdoor Use Extension Cords
1. When product is used outdoors, use only extension cords marked for outdoor use.
2. Use only UL listed extension cords. Never use damaged or altered extension cords.
3. Follow extension cord manufacturer safety instruction.
Extension Cords
1. Make sure your extension cord is in good condition.
2. When using extension cords, be sure to use one heavy enough to carry the current your product
requires. An undersized cord will cause a drop in line voltage resulting in power loss and
overheating. Reference Table 1 below for the correct size to use depending on cord length and
nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.
A
Fountain
1
B
Electric Pump
1
C Saddle 1
D Bowl Cover
1
Figure 1
Grounded
Outlets
1.
(SEE FIGURE 1)
Position the fountain where
you want it and connect the clear tube from
the fountain (A) to the pump spout (B).
Assure the tube is fully seated on the spout
and place pump in bowl of fountain (A). Cord
goes out the back of the fountain.
2. Insert the bowl cover (D) into the fountain (A)
bowl to cover the pump. Fill the fountain (A)
bowl with water. If possible use distilled water
to fill.
3. Set the saddle (C) on top of fountain crossbar.
4. Plug power cord into properly grounded
120V AC outlet.
Adjust Speed of Water Flow
1. Unplug pump (B) from AC power outlet.
2. Move adjustment switch on pump (B)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check electric pump (B),
and fountain (A) water pipe for clogs.
NOTE:
Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
A
A
C
A
B
D
