Aston Global SD974-L, Инструкция по установке и эксплуатации, Страница: 11 / 21

Locate the brackets for the bottom of the fixed glass panels in the Accessory box
this unit uses 2 brackets one on each panel.
Place the bracket into slot at the bottom of the fixed glass panel center with the
glass and mark the mounting hole. After marking remove the bracket and slide the
fixed glass panel towards the interior of the unit to gain access to drill a pilot hole
for the mounting screw.
Using a 1/8” drill bit drill the pilot hole for the mounting screw. Place a small mount
of silicone to the bottom of the bracket and install onto the shower tray using the
mounting screw provided.
Slide the fixed glass panel back into place and install the remaining components of
the bracket use the 2 silicone flat washers provided and hardware.
Repeat this process for the other fixed glass panel.
Next locate the braces for the top of the fixed glass panels also located in the
Accessory box this unit uses 2 braces.
Assemble one of the braces installing both end mounting brackets onto the rod see
drawing for configuration.
Place the assembled rod onto one of the fixed glass panels and move the brace
until the brace for flush against the wall and is fully installed onto the glass panel.
Using an erasable pencil mark the location of the brace on the wall.
Repeat this process on the other glass panel.
Using the appropriate drill bit fro your wall surface drill each mounting location with
a 5/16 diameter drill bit. Install the plastic wall anchors provided into the drilled
hole.
NOTE: If your surface is prone to cracking or chipping then it is
recommended that you pilot drill first using a smaller drill bit and then step
up to the final size.
Finally install the rubber magnet seals on the fixed glass panels.
10