Astin Trew AT 3000, Руководство по эксплуатации

Страница: 10 / 13

event of failure during the warrantee
period can be carried out by your deal-
er or distributor.
The high quality dual triode valve fitted
in the AT3000 has been selected to
offer an audiophile sound.
If you wish to experiment with alterna-
tive manufacturers’ valves after the
warrantee period has expired, ensure
that the factory fitted valve is replaced
with a 6922 type only. Other valve
types may damage the CD Player. If
you attempt to replace the valve, the
following instructions must be adhered
to.
Note: Dangerously high voltages
are present inside the unit, when
powered from the mains supply,
that can KILL.
NEVER open the CD Player when
attached to the mains supply.
A .Disconnect the AT3000 from all
equipment and the mains supply.
Place on a table or work bench
with plenty of space around the
CD Player.
Note: Wait at least 1 hour before
opening the top cover to allow the
valve time to cool down.
B .Undo the 10 x M3 Alan screws
holding the top plate in position.
Put the screws somewhere safe.
C .Remove the top plate, place on a
the prog button on the remote.
Enter the first track required as per
TRACK SELECTION instructions above.
If you enter the wrong track, press
the
■
button on the remote and re-
enter.
Then enter up to 19 more track selec-
tions when the display will show
‘FULL’
and flash.
Press the play/pause button on facia
or
➤
/II on remote to play selection.
To cancel the programmed selection,
press the
prog button on the remote
again.
MUTE:
Press the mute button on the remote
and the display will show ‘MUTE’ . The
CD will continue to play silently. Press
‘MUTE’ again and the CD will again
play. If you are using the ASTINtrew
pre-amplifier, this will also mute as
well.
STOP:
Press the stop button on the facia or
■
button on the remote to stop the
CD.
7. Valve and fuse replace-
ment.
Replacing the valve in the unlikely
9