SPECIFICATIONS FOR 105-2
TWO-YEAR LIMITED WARRANTY
Omnitronics, LLC (“ASTATIC”) hereby warrants that this product will be free of defects in material and workmanship for a period
of two years from the date of purchase. In the unlikely event a defect occurs ASTATIC will, at its option, either repair or replace with
a new unit of equal or greater value. You should retain proof of purchase to validate the purchase date and return it with any warranty
claim. Return warranty claims carefully packed, insured and prepaid to the Service Department at the address listed below.
This warranty excludes exterior finish or appearance, damage from abuse, misuse of the product, use contrary to ASTATIC’s
instructions or unauthorized repair. All implied warranties or merchantability or fitness for a particular purpose are hereby disclaimed
and ASTATIC hereby disclaims liability for incidental, special or consequential damages resulting from the use or unavailability of
this product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not
allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the
above exclusions and limitations may not apply to you. ALL RETURNS MUST BE PRE-APPROVED. PLEASE CALL 440-593-
1111 FOR A RETURN AUTHORIZATION NUMBER.
Note: No other warranty, written or oral is authorized by Omnitronics, LLC.
Specifications
Generating Element:
Dynamic
Polar Pattern:
Omnidirectional
Frequency Response:
50 Hz - 13 kHz
Output Level:
-76 dB (0dB = 1 volt / microbar)
1.58mV/PA
I
mpedance:
Low (400 ohms nominal)
Cable:
2.1m (7ft.) of four connector, two shielded, permanently attached,
rugged jacketed cable.
Switch:
DPDT professional sealed micro switches, operated with simple
push buttons.
Dimensions:
34.9mm (1 3/8") diameter x 115.9mm (4 9/16")
Weight:
198.5 grams (7oz.)
Finish:
Black Cycolac cap, chrome plated screen, black cycolac housing.
Phasing:
Positive pressure (movement of the diaphragm inward) will generate
a positive voltage on the red cable lead with respect to the black
cable lead.
Cable connections:
Connect cable leads Red and Black to balanced line input, White
and Shield (red button) for relay control for one zone, Green and
Shield (black button) for relay control for the other zone.
46873-56-00 / Rev.1/7-30-04 / S.W.
