AST SIDE CUT SAW, Руководство владельца/оператора

Страница: 7 / 15

Engaging Saw the First
Time
If this is your initial
startup with this attachment on this
machine, check the skid steer’s
hydraulic oil level and add oil, if
necessary, before and after doing
steps 1- 3 below.
After starting the skid steer, lift the
a
ttachment 6” (152mm) off the ground
surface:
1. With the skid steer engine RPMs
just above idle, slowly engage the
auxiliary hydraulic to rotate the
saw. If the saw blade does not
turn at all, check the hydraulic
circuit connections between the
saw and skid steer.
2. Lower the tree saw attachment to
the ground, set the brake and
shut off the skid steer’s engine
and exit the operator’s
compartment.
3. Check the skid steers hydraulic oil
level, and add oil if necessary.
4. Inspect the tree saw’s hydraulic
plumbing for any noticeable leaks.
Correct these leaks before
continuing.
Stopping the Saw
The saw blade quits rotating when the
auxiliary control is neutralized. When
you are done cutting, stop the saw
blade’s rotation before exiting the
operator’s cab.
Getting Familiar with
the Attachment
Never operate the
saw when bystanders are within 100’
(30 m) of your work area. Flying &
falling debris could result in Death or
Serious Injury.
Be cautious when
operating on un-level ground
surfaces. A machine roll over could
result in Minor or Serious Injury.
Always wear your seat belt when
operating this type of machinery.
Before starting the skid steer engine
with this saw attached, make sure you
are knowledgeable and comfortable
with the operation of the tree saw
controls as outlined in the previous
and following sections of this manual.
Always be aware of your surroundings.
While watching the saw, also pay
attention to what obstacles or terrain
are in front of the saw and prime
mover’s wheels.
Cutting tree
branches with the saw in an elevated
position could result in Death or
Serious Injury if the skid steer
becomes unstable. Never raise the
saw more a few feet off the ground
when working on slopes or uneven
terrain.
Adjusting Saw Height &
Level
Use the skid steer loader lift to adjust
the elevation of the saw. The fore & aft
leveling can be accomplished by using
the skid steer’s attachment tilt
cylinders.