8421, qty 2
offset steering
block
8413, qty 2
hinge pin
8179, qty 2
spacer
8439, qty 4
8-32 x 5/8
6917, qty 2
4-40 x 3/8
1:1
1:1
1:1
8413
8413
8413
4449
4448
6299
8423
8429
8425
6299
8413, qty 4
caster shim
(white plastic)
6299, qty 6
E-clip
1:1
4448, qty 2
ball end
4449, qty 2
4-40 locknut
1:1
3213, qty 2
axle
8423, qty 2
kingpin
8429, qty 2
spring, .020
1:1
8425, qty 10
kingpin shim
1:1
1:1
8402, qty 1
cross brace
6917
8402
8439
8179
9
the side with
the rounded corner
should face up
chassis
1:1
4187, qty 4
spacer
1:1
4187
UPPER ARM TO THE SUSPENSION MOUNT
Assemble the upper arm assembly to the suspension mount as
shown, using the #8413 hinge pin and #8413 shims.
FINAL FRONT SUSPENSION ASSEMBLY
Assemble the #8421 steering block as shown using parts
#3213, 6299, 4448, 4187, and 4449. Install the ball end into the
rear hole.
Place one #6299 E-clip on the bottom of the #8423 kingpin then
slide the #8429 spring over.
Slide the #8423 kingpin completely through the bottom of the
suspension arm and up through the steering block.
Place one #8425 shim on top of the #8421 steering block.
Now push the upper arm over the kingpin. Place four #8425
shims over the kingpin and secure with a #6299 E-clip.
Do the other side.
8425
8421
3213
6299
4187
SUSPENSION ARMS TO CHASSIS
Slip the #8179 spacer between the
suspension arm and the chassis, then bolt
on with two #8439 blue aluminum screws
from underneath the chassis. Do the other
side.
MOUNT THE CROSS BRACE
Mount the #8402 cross brace to the front
suspension using two #6917 button head
screws.
chassis
The RC10L3 Oval requires
the #8403 cross brace,
available separately.
2
FRONT
FRONT
