P/N
-
-
Rev D
YRL SLKFTSINSTL FUL
16
Definitions
All Code Lockout Mode:
This feature is enabled by the Master code. When enabled, it restricts all user (except Master) PIN
code access. When attempting to enter a code while the unit is in Lockout, the
locked padlock will appear on the
RED
screen.
Automatic Re-lock Time:
After a successful code entry or manual unlock with the key, the lock will automatically re-lock
after each unlock in an effort to keep your home secure. This feature is optional, and can be turned off. In the ON mode, the
lock will automatically re-lock after thirty (30) seconds.
Inside Indicator Light:
Located on the interior escutcheon. Shows active status (Locked) of lock and can be enabled or
disabled in the
(Main Menu selection #3).
Advanced Lock Settings
Language Setting Mode:
Choosing English (1), Spanish (2) or French (3) becomes the (default) setting for the lock's voice
prompts.
Low Battery:
When battery power is low, the Low Battery Warning indicator flashes
. If battery power is completely
RED
lost, use the 9Volt battery override. To use the 9V battery override apply 9V battery, in either direction, to terminals below
the touchscreen for backup power option. Wake up the lock and enter your pin code to unlock the door.
Master
Code:
It must be created prior to
PIN
The Master
code is used for programming and for feature settings.
PIN
programming the lock.
The Master code will also operate (unlock/lock) the lock.
Network Module Setting:
With the optional Network Module installed, this setting becomes available thru the Main Menu
(7) and allows the lock to connect with a network controller.
One Touch Locking:
When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-lock
duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is
in use
any valid
code will
not
(disabled),
PIN
re-lock the lock.
Previous:
While in Menu Mode, pressing this icon cancels the current operation and returns the user to the previous step.
Privacy Mode:
Privacy mode is disabled by default. Enable Privacy mode by pressing the privacy button for 4 seconds to
put the lock in do-not-disturb mode (all pin codes are disabled).
Shutdown Time:
The unit will shutdown (flashing
) for sixty (60) seconds and not allow operation after the wrong code
RED
entry limit (5 attempts) has been met.
Tamper Alert:
Audible alarm sounds if attempting to forcibly remove outside lock from door.
User
Code:
PIN
The user code operates the lock. The maximum number of user codes with Z-Wave Plus or ZigBee network
module is 250; without network module or with iM1 network module, maximum is 25; with Bluetooth, maximum is 12.
Note: When deleting user pin code(s), screen will display user pin code being deleted.
Volume Setting Mode:
Low (2)
The volume setting for
code verification is set to
by default; otherwise it can be set to
PIN
High (1)
Silent (3)
or
for quiet areas.
Wrong Code Entry Limit:
After five (5) unsuccessful attempts at entering a valid
code, the unit will shut down and not
PIN
allow operation for sixty (60) seconds.
