6
An ASSA ABLOY Group brand
P/N 80-9150-0065-010 Rev B
Adjust Lock for Door Thickness (If Necessary)
1. Remove cylinder handle:
A. Insert key and rotate 45 degrees counterclockwise.
B. Insert lever retainer tool and push.
C. Slide lever off lock.
2. Remove the plastic sleeve from the old cylinder.
3. Slide new cylinder into sleeve.
4. Insert key into cylinder.
Important: Make sure the key cut side of key lines
up facing towards the end of the lever. If the key is
inserted incorrectly, the lock will reassemble and
might appear to properly work; however, when the
key is removed, the latchbolt will remain retracted.
5. Rotate key 45 degrees counterclockwise.
Depress retainer plate, push the handle onto the shank until fully seated.
Pull on handle to insure properly seated.
2-5/8" (66.5) For 6 pin cylinders, 1-3/8" thick doors
2-7/8" (73) For 6 pin cylinders, 1-3/4" thick doors ONLY
1-3/16" (30) For 6 pin cylinders, 1-3/8" thick doors
1-7/16" (36.5) For 6 pin cylinders, 1-3/4" thick doors ONLY
CAUTION: The cylinders furnished with inTouch™ lock for use in 1-3/8" doors have a tailpiece
that is 1/4" shorter than the standard cylinders that are furnished for 1-3/4" doors. Trying to
install a standard cylinder in 1-3/8" will DAMAGE the lock body.
How to Replace, Re-Key or Install Cylinder
A
C
B
Key cut
Lock is packed pre-adjusted for 1-3/4" (44mm) doors.
To adjust for thinner door:
A. Remove (2) screws from outside
support assembly.
B. Slide outside assembly away
from the lock body.
C. Disengage plate from assembly
by sliding to the side and removing.
D. Re-seat plate on outside assembly.
Plate hole is slightly off center
(gray area). Slide plate over
assembly and slide to the center
until seated in one of the two grooves.
E. Adjust for door thickness by
seating plate in grooves on
assembly to match door thickness.
F. Re-seat plate on assembly.
G. Fasten plate and outside assembly to lock body with (2) screws.
Position for 1-3/4"
thick doors
Position for 1-3/8"
thin doors
C
E
B
Slide Plate to re-seat in grooves
D
F
G
A