7
ASSA ABLOY Hospitality
66 1100 005-11
FCC (Federal Communications Commission)
statements
for BLE module
This device comply with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) The BLE Module may not cause harmful interference, and
2) The BLE Module must accept any interference received, including interference that
may cause undesired operation.
Important note:
To maintain compliance with FCC´s RF exposure guidelines, this equipment
should be installed and operated with minimum distance 20 cm between the radiator and your
body. Use only the supplied antenna.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any
other antennas or transmitters.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The concerned end product must be labeled to say
‘
Contains FCC ID: Y7V-7001CC1
’.
The label stating this can be seen by opening the back cover of the Host System; the label is
attached on the Host System, and is seen directly.
ISED (IC) statements for BLE module
This device comply with Industry Canada licence-exempt RSS standard
CAN ICES-3 (B)/
NMB-3(B) B
. Operation is subject to the following two conditions:
1)
The BLE Module may not cause interference, and
2)
The BLE Module must accept any interference, including interference that may
cause undesired operation of the device.
Important note:
To comply with Industry Canada RF radiation exposure limits for general
population, the antennas used for these transmitters are exempted from
Routine Evaluation
Limits – SAR Evaluation
in accordance with
RSS-102 section 2.5.1
.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
