PN# 500-19900
Page 7
Rev. F, 04/11
After proper strike spacing has been established, determine the correct roll pins to use. If 1-
2 washers are utilized, use the 3/4” [19.1mm] long roll pins (Item #10). For 3-4 washers,
use the 1” long roll pins (Item #11).
Remove the strike plate from the Z-Bracket and place on a clean, flat surface. Using a
hammer, insert and lightly tap to install the two (2) roll pins (Item #10 or #11) into the
two (2) 1/4” [6.4mm] diameter recesses of the strike. Note: Care should be taken when
installing roll pins into the strike. Excessive impact to the strike or over-driving the pins into
the recesses may distort the contact surface of the strike which will affect the holding force of
the lock.
Install the strike inserting the screw into the Z-Bracket T-Nut and aligning the roll pins into
the bushings. Using a 3/16” hex wrench, tighten the 5/16-18 flat head screw into the T-Nut
until it is snug. Note: Do not over tighten. When the strike is fully installed there should
be some play or flexing of the strike around the washers. This allows the lock to pull the
strike into the correct alignment for maximum holding force.
Dress Cover Installation: After all adjustments to the bracket installation have been
completed, install the dress cover as follows:
a.
Using a clean cloth and a household cleaner, wipe off the back of the Z-Bracket and allow
it to dry.
b.
Remove the backing from the two (2) strips of tape on the inside of the cover.
c.
With the door closed, vertically position the cover open-end-up to the desired location,
and then visually align the cover horizontally so that there is an equal spacing of
clearance to each side of the lock inside the cover.
d.
Firmly press the cover into place against the back of the Z-Bracket to secure.
IF ADDITIONAL INSTALLATION ASSISTANCE IS REQUIRED
CALL SECURITRON TOLL FREE: 1-800-MAG-LOCK
