3
A7858F 10/20
1-800-727-5477 • www.sargentlock.com
DL Series
Installation Instructions
Tubular Lock
Copyright © 2008, 2009, 2012, 2016, 2020, SARGENT Manufacturing Company. All rights reserved. Reproduction in
whole or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
4
Installation, Continued.
Install DLU93
1. Install Mounting Plate Assembly
A. Locate holes in mounting plate assembly over center punch marks.
Note: Location of set screw
B. Install (2) combo screws and tighten to secure mounting plate assembly
to door
2. Install Rose & Lever
A. Install rose onto mounting plate assembly and rotate clockwise to
tighten
B. Install lever onto spindle. Insert setscrew into hole in lever and tighten.
93 Function Parts List Description:
1-
Mounting plate assembly, 2-Combo screws (2), 3-Rose, 4-Lever, 5-Set screw
Install TB-DLU93 & DLU94
1. Install Thru-Bolting Assembly
A. Locate studs from Rose Assembly or O/S Thru Bolt Plate
Assembly into 1/4" drill holes on outside of door
B. Locate Mounting Plate Assembly on inside of door.
Install (2) machine screws and tighten to secure.
2. Install Rose & Lever
A. Install rose onto mounting plate assembly and rotate
clockwise to tighten.
B. Install lever onto spindle. Insert setscrew into hole in lever
and tighten. Repeat process for Outside Lever (94 Function
only).
94 Function Parts List Description:
1-Mounting Plate Assembly, 2-#6 X 3/4" Machine Screws (2), 3-Rose, 4-Lever(2),
5-Set screw (2), 6-Rose Assembly
TB- 93 Function Parts List Description:
1-Mounting Plate Assembly, 2-#6 X 3/4” Machine Screws (2), 3-Rose, 4-Lever,
5-Set screw, 7-Outside Thru-Bolt Plate Assembly
5
Square Rose Installation
TO
P
HINGE
1. Install lock per instructions on page 2. Square rose installation begins after spring housing installation.
2. Position square mounting plate over spring housing as seen in Figure 1 on page 4.
3. Drill two centered pilot holes for the #6 mounting screws in the upper right and lower left portions of the square
mounting plate.
4. Loosely attach mounting plate to both sides of the door with screws.
5. Square top surface of mounting plate to edge of door
NOTE: The right angled square MUST be on the flat surface
of the square mounting plate for proper leveling.
6. Tighten
mounting
screws
7. Press rose onto mounting plate, fasten lever with set screw.
Parts List Description:
1-Square mounting plate,
2-#6 x ¾" Machine Screws (2), 3-Rose, 4-Lever (2), 5-Set Screw (2)
Tools Needed:
Drill, Pilot bit, Phillips screw driver,
Right angle square
1
2
3
4
5
1
2
3
4
5
6
5
7
4
4
5
3
2
1
