Copyright © 2016, 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9316-2534-020 Rev 2 04/20
2
• For special applications, a separate door and frame
preparation template is packed with these instructions. Use
this instruction sheet for installation sequence and closer
adjustments only.
• Doors should be hung on ball bearing or anti-friction hinges.
• Door and frame must be properly reinforced.
Mounting Hardware
Door or Frame
Drill
Closer:
1/4-14 x 1-1/2 Oval Flat Head Mach. Screw
Wood
3/16" (4.76mm)
Closer:
1/4-20 x 3/4 Oval Flat Head Mach. Screw
Metal
Drill #7 (.201 dia. or 5.10mm)
Tap 1/4-20
Arm Foot:
Sleeve Nut and Bolt (SNB)
Hollow Metal
9/32" (7.00mm) thru
3/8" (9.50mm) door face opposite to closer
Aluminum or Wood 3/8" (9.50mm) thru
Arm Foot:
Thru Bolt and Grommet Nut (TBGN)
(optional)
All
9/32" (7.00mm) thru
3/8" (9.50mm) dia. x 3/8" (9.500mm) deep,
door face opposite to closer
• Always consult door/frame manufacturer for fastener
compatibility.
• Adjust closing time speed between 4 and 7 seconds from
90° to 0°. Use of door by handicapped, elderly or small
children may require greater closing time.
• These door closers should NOT be installed on exposed side
(weather side) of exterior doors.
• Dimensions are given in inches (millimeters).
ATTENTION:
An incorrectly installed or improperly adjusted door closer can
cause property damage or personal injury. These installation
instructions should be followed to avoid the possibility of
misapplication or misadjustment.
J1600 UniTrol Arm Closer
Closer Adjustments
Latch
Backcheck
Use provided 1/8" hex wrench to
turn valves.
NEVER force valves out of closer.
NEVER completely close
backcheck valve. Backcheck
is not a positive stop.
Door must be open to adjust
spring closing power. Refer to
chart.
Do not use a power drill.
Warranty will be void.
Sweep
2
3
4
5
6
8
10
11
12
14
Top
Jamb
Do not over tighten
screws
Pinion Cap
Screw pinion cap onto pinion
shaft by hand or with a Phillips
screwdriver.