Page 5.
08.11.11
Step 20: Installing Top Section Hardware
Place the top section face down on your padded saw horses.
Locate the Stile Stiffener(s).
Note:
If struts are not required, skip to Step 22.
Step 21: Strut Installation
If Strut(s) are required, location is shown on page 8. Install
using (2) 1/4”x 1” TEK Screws into each end stile (Figure 14C).
Attach Strut(s) to the center stile with (2) 1/4”x 1“ TEK Screws,
(Figure 14A).
Note:
Due to lack of available head room (refer to Page 2,
Table 1), you may require a Low Head Room application. If this
is the case, skip Step 22 and go to Step 23.
Step 22: Top Fixture Installation (Standard Head
Room)
Align the Top Fixtures with holes on the end stiles. Secure the
fixture to the end stiles with (3) 1/4” x 1“ TEK Screws (Figure
13A). Insert Rollers as shown (Figure 13A). Leave the slide loose
for adjustment later.
Step 23: Top Fixture Installation (Low Head Room)
Attach the Flat Top Fixture (for Low Head Room applications),
(Figure 14B) on the top corner of the end stiles. Secure the
fixture to the end stiles with (2) 1/4”x 1” TEK Screws (Figure
14B). Insert Rollers as shown (Figure 14B). If a strut is required,
refer to Step 21 for instructions. In this case the Strut will
mount on top of the lower portion of the Low Head Room Flat
Top Fixture (Figure 14B).
Step 24: Stacking the Top Section in the Opening
Carefully lift the Top Section, with the rollers, top fixtures and
struts (if required). Slowly lower the section on to the
previously installed intermediate section. Temporarily secure
the top section by driving a 16-penny nail into the header and
carefully bending it over (Figure 15A).
Step 25: Center Hinge(s) Installation
Once the top section is secured, push up the upper leave(s) of
the Center Hinge(s) and attach to the upper section with (2)
1/4“x 1” TEK Screws (Page 4, Step 18).
Step 26: Roller Hinge Installation
Once the top section is secured, push up the upper leave(s) of
the Roller Hinge(s) and attach to the top section with (2) 1/4”x
1” TEK Screws (Page 4, Step 19).
B
Figure 15
A
Top
Intermediate
Intermediate
Bottom
B
C
Figure 13
Center Stile
TEK Screws
A
Figure 14
C
TEK Screws
B
TEK Screws
TEK Screws
A
