15
SE LP10 CL33600 Cylindrical Lock
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
7) Installation Instructions (Continued)
Fig. 7a
Fig. 7b
Outside Face of Door
7.
Installing Lock
- Feed lock body and harness through 2-1/8” diameter hole from outside
of door (Fig. 7a). Be sure latch engages lock body as shown (Fig. 7b).
Important
: Door must remain open during installation. Use door stop.
8.
Install Inside Spring Cassette:
a. Feed lock body wires and cassette (REX) wires in slot on face of door (Fig. 8a)
Note: Be careful to keep wires in slot cut into door.
b. Tighten using two #12-24 screws.
Note: DO NOT PINCH wires when tightening.
Fig. 8a
Fig. 8b
Inside Face of Door
Keep wires in slot:
DO NOT pinch under
Spring Cassette
Lock Body Wires
REX Wires
Ground Wire
Spring Cassette
