®
ASSA ABLOY
Step 12: Install Covers
Check to assure all latches are working properly before the covers
are installed.
To install the end cover, position the bar cap into the side facing the
touchbar and place the end cover's lower edge into position on the
rail. Rotate the upper edge on the end cover up and snap it into the
rail. The holes for the end cover will line up with the fastener holes in
the rail. Secure the end cover with (4) #8 by 1/2" fasteners provided.
(2 on top and 2 on bottom.)
Place the end cap into position on the end of the rail and secure with
the three #8 by 1/4" long fasteners provided.
Place the front cover over the latch head assembly and secure with
the two #8 by 1/4" long fasteners provided.
Place the top chassis cover over the Top Chassis and secure with the
four #8-32 by 5/16" long fasteners provided.
Place the Bottom Chassis Cover over the Bottom Chassis and
secure with the four #8-32 by 5/16" long fasteners provided.
Place the top and bottom Rod Guide Covers over the Rod Guides
and fasten each cover with #6 by 3/8" long fasteners provided.
End Cover
Bar Cap
End Cap
FASTENERS:
#8-32 Flat Head Undercut Machine - Phillips
1/4"
#8-32 Th'd - #6 Oval Head Machine - Phillips
5/16"
#6 Truss Head Tapping - Phillips - Type A
#8 Truss Head Tapping - Phillips - Type A
3/8"
1/2"
FM329 (11/18)
11 of 14
Front
Cover
Copyright © 2012 Corbin Russwin Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
