12
Installation Instructions
Exit Devices
FM572 10/22
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
ED2400 & ED2400(A) Series Surface Vertical Rod
4
Installation, continued
c
Prepare Rods
Figure 13
Figure 14
Jig
Dia. Thru
1/8"
(3.20 mm)
3/8"
(10 mm)
Rod
(Typical pin end)
Bolt
Bottom
Rod
1/8" x 1/2" Rollpin
Bottom Rod
Connector
32-1/4"
(818 mm)
3-3/4"
(95 mm)
Adjustment left:
1/2" (13 mm) in-out.
PRESS FLUSH
To Lenghten Rods (Figure 13)
• Use Rod Extension(s) to extend Rod to length needed or
longer (2”, 6”, 12”, or 24” Rod Extensions available).
• Cut excess length from end of rod with pin hole.
• Apply screw locking compound (available at automotive parts
store) to Rod Extension(s) male threads. Thread Extension(s)
until seated tight over Rod.
To Cut Rods (Figure 14)
• Cut from the end with pin hole. NEVER CUT THREADED END.
• Press Jig until it bottoms over Rod.
• Drill 1/8” (3 mm) dia. hole thru, 3/8” (10 mm) from end of
Rod.
Bottom Rods (Figure 18)
• Ready for 39-15/16” (1014 mm) Floor to device center.
To Lower Device
• Bottom Rod cutoff length is distance that device was lowered
below 39-15/16” (1014 mm).
• Add to top rod a length equal to the bottom rod cut.
Example:
Device at 36” (914 mm) from floor
39-15/16” - 36” = 3-15/16” (100 mm)
The top rod must be lengthened 3-15/16” (100 mm)
