Assa Abloy Aperio, Установка и интеграция

Страница: 9 / 15

Copyright © 2011, ASSA ABLOY All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY is prohibited.
WFMN5A • PAGE 8
DIP 1-DIP4: Controls RS485 addressing BIT 0-BIT 3.
ON: Address bit set.
OFF: Address bit NOT set.
ƒ
Addresses “1” to “15” are available using dip switch configuration.
ƒ
Each Communication Hub connected to the same RS485 bus must have a unique RS485 address.
ƒ
An address of “0” disables the EAC interface of the Communication Hub
DO NOT
use this configuration
for normal installations. It also sets the Communication Hub in constant pairing mode.
ƒ
See RS485 Addressing Reference on Page 9.
DIP 5: Not used.
DIP 6: Controls use of RS485 pull down resistor.
ON: 620 Ohm pull down connected /enabled.
OFF: 620 Ohm pull down disconnected /disabled.
DIP 7: Controls use of RS485 pull up resistor.
UP: 620 Ohm pull down connected /enabled.
DOWN: 620 Ohm pull down disconnected /disabled.
DIP 8: Controls use of termination resistor between RS485 A and RS485 B.
ON: 100 Ohm connected /enabled.
OFF: 100 Ohm disconnected /disabled.
DIP 9: Not used.
DIP 10: Controls use of external antenna if required.
ON: Selects use of internal antenna.
OFF: Selects use of external antenna.
AH13/AH30
DIP Switch
Configuration
AH13/AH30
DIP Switch
Configuration
Table
DIP S
wItch
N
umber
L
abeL
D
eScrIPtIoN
1-4 A0
A1
A2
A3
Controls RS485 addressing BIT 0-BIT 3.
ON => Address bit set.
OFF => Address bit NOT set.
See RS485 Addressing Reference on Page 9.
5 A4 Not Used.
6 DOWN Controls use of RS485 pull down resistor.
ON => 620 Ohm pull down connected /enabled.
OFF => 620 Ohm pull down disconnected /disabled.
7 UP Controls use of RS485 and pull up resistor.
ON =>620 Ohm pull up connected /enabled.
OFF => 620 Ohm pull up disconnected /disabled.
8 TERM Controls use of termination resistor between RS485 A and RS485 B.
ON =>100 Ohm termination resistor connected /enabled.
OFF => 100 Ohm termination resistor disconnected /disabled.
9 Not used.
10 INT/EXT Controls use of external antenna if required.
ON =>Selects use of internal antenna.
OFF => Selects use of external antenna.