ASROCK Z390 Pro4, Руководство пользователя

Страница: 24 / 176

22
English
USB 3.1 Gen1 Headers
(19-pin USB3_3_4)
(see p.1, No. 7)
(19-pin USB3_5_6)
(see p.1, No. 18) There are two headers on
this motherboard. Each
USB 3.1 Gen1 header can
support two ports.
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 23) This header is for
connecting audio devices
to the front audio panel.
Chassis/Water Pump Fan
Connectors
(4-pin CHA_FAN1/WP)
(see p.1, No. 17)
(4-pin CHA_FAN2/WP)
(see p.1, No. 2)
(4-pin CHA_FAN3/WP)
(see p.1, No. 16) Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
J_SENSE
OUT2_L
1
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to
connect them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel
and adjust “Recording Volume”.
1
In
Dummy
IntA_PB_D-
GND
IntA_
GND
IntA_PB_SSTX-
IntA_
IntA_PB_SSRX-
Vbus Vbus
Vbus
IntA_PA_SSRX-
IntA_
GND
IntA_PA_SSTX-
IntA_
GND
IntA_PA_D-
In
GN D
FAN_VOLTAGE
CHA_FAN_SPEED
FAN_SPEED_CONTROL
4 3 2 1
1
In Dummy IntA_PB_D- GN
D
IntA_
GN
D
IntA_PB_SSTX- IntA_ IntA_PB_SSRX- V
bus
V
bus
V
bus
IntA_P
A_SSRX-
IntA_P
GN
D
IntA_P
A_SSTX-
IntA_P
GN
D
IntA_P
A
_D-
IntA_P
A
_D+