ASROCK X470 Taichi, Руководство пользователя

Страница: 35 / 214

English
32
(19-pin USB3_9_10)
(see p.1, No. 14)
Front Panel Type C USB
3.1 Gen2 Header
(26-pin F_USB31_TC_1)
(see p.1, No. 12) There is one Front
Panel Type C USB 3.1
Gen2 Header on this
motherboard. This header
is used for connecting a
USB 3.1 Gen2 module for
additional USB 3.1 Gen2
ports.
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 30) This header is for
connecting audio devices
to the front audio panel.
1
In
Dummy
IntA_PB_D-
GND
IntA_
GND
IntA_PB_SSTX-
IntA_
IntA_PB_SSRX-
Vbus V
V
bus
IntA_PA_SSRX-
IntA_
GND
IntA_PA_SSTX-
IntA_
GND
IntA_PA_D-
In
J_SENSE
OUT2_L
1
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to connect
them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel and
adjust “Recording Volume”.