1 1
2.5 Installation of Memory Modules (DIMM)
P4VX4 motherboard provides four 184-pin DDR (Double Data Rate) DIMM slots
(DDR1: blue, DDR2: black, DDR3: blue, DDR4: black).
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1.
Unlock a DIMM slot by pressing the retaining clips outward.
Step 2.
Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
Step 3.
Firmly insert the DIMM into the slot until the retaining clip snap back in place
and the DIMM is properly seated.
2.6 Expansion Slots (PCI and AGP Slots)
There are 5 PCI slots and 1 AGP slot on P4VX4 motherboard.
PCI slots:
PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AGP slot:
The AGP slot is used to install a graphics card.
The ASRock AGP slot has a special locking mechanism which can
securely fasten the graphics card inserted.
Do NOT use a 3.3V AGP card on P4VX4’s AGP slot!
It may cause permanent damage!
Installing an expansion card
Step 1.
Before installing the expansion card, read the documentation of the
expansion card and make necessary hardware settings for the card.
Step 2.
Remove the system unit cover (if your motherboard is already installed in a
chassis).
Step 3.
Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
Step 4.
Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5.
Fasten the card to the chassis with screws.
Step 6.
Replace the system cover.
