ASROCK N68-GS4/USB3 FX R2.0, Руководство по установке

Страница: 10 / 45

1 0 1 0 1 0 1 0 1 0
ASRock N68-GS4/USB3 FX Motherboard
E
n
gl
is
h
E
n
gl
is
h
E
n
gl
is
h
E
n
gl
is
h
E
n
gl
is
h
FLOPPY 1
Pin 1
the red-striped side to
Pin1
1.5 Onboard Headers and Connectors 1.5 Onboard Headers and Connectors
1.5 Onboard Headers and Connectors 1.5 Onboard Headers and Connectors 1.5 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 17)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector
(39-pin IDE1, see p.2 No. 5)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA2 Connectors These four Serial ATA2 (SATA2)
(SATAII_1 (PORT 0.0):
connectors support SATA2
see p.2, No. 6)
or SATA hard disk for internal
(SATAII_2 (PORT 0.1):
storage devices. The current
see p.2, No. 7)
SATA2 interface allows up to
(SATAII_3 (PORT 1.0):
3.0 Gb/s data transfer rate.
see p.2, No. 8)
(SATAII_4 (PORT 1.1):
see p.2, No. 9)
connect the black end
to the IDE devices
connect the blue end
to the motherboard
IDE 1
PIN1
80-conductor ATA 66/100/133 cable
SATAII_1
(PORT 0.0)
SATAII_2
(PORT 0.1)
SATAII_3
(PORT 1.0)
SATAII_4
(PORT 1.1)
DUMMY
GND
GND
P+
P-
USB_PWR
P+
P-
USB_PWR
1
USB 2.0 Headers Besides two default USB 2.0
(9-pin USB3_4)
ports on the I/O panel, there are
(see p.2 No. 12)
two USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.