ASROCK M3A790GMH 128M, Руководство пользователя

Страница: 46 / 63

4 6 4 6 4 6 4 6 4 6
BIOS SETUP UTILITY
CPU Configuration
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Advanced
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
CPU Frequency (MHz)
PCIE Frequency (MHz)
Overclock Mode
[200]
[100]
[Auto]
Spread Spectrum
Enhanced Halt State
L3 Cache Allocation
Advanced Clock Calibration
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
[Auto]
[Enabled]
[Auto]
[Enabled]
[Disabled]
[Auto]
[Disabled]
Select the over clock
mode.
Processor Maximum Frequency
North Bridge
Processor Maximum Voltage
Maximum Frequency
x10.5 2100 MHZ
x9.0 1800 MHz
1.2500 V
Multiplier/Voltage Change [Manual]
Processor Target Frequency
North Bridge Target Frequency x10.5 2100 MHZ
x9.0 1800 MHz
CPU Frequency Multiplier
For safety and system stability, it is not recommended to adjust the value of
this item.
CPU Voltage
It allows you to adjust the value of CPU voltage. However, for safety and
system stability, it is not recommended to adjust the value of this item.
NB Frequency Multiplier
For safety and system stability, it is not recommended to adjust the value of
this item.
NB Voltage
It allows you to adjust the value of NB voltage. However, for safety and
system stability, it is not recommended to adjust the value of this item.
HT Bus Speed
This feature allows you selecting Hyper-Transport bus speed. Configura-
tion options: [Auto],[x1 200 MHz] to [x5 1000 MHz]. If you adopt Phenom
CPU, the configuration options are: [Auto], [x1 200 MHz] to [x13 2600 MHz].
The configuration options depend on the CPU you adopt.
HT Bus Width
This feature allows you selecting Hyper-Transport bus width. Configura-
tion options: [Auto], [8 Bit] and [16 Bit].
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is
recommended to keep the default value for system stability.