ASROCK B460 Pro4, Быстрое руководство по установке

Страница: 23 / 190

21
English
B460 Pro4
USB 3.2 Gen1 Headers
(19-pin USB3_5_6)
(see p.1, No. 25)
(19-pin USB3_7_8)
(see p.1, No. 9)
There are two headers on
this motherboard. Each
USB 3.2 Gen1 header can
support two ports.
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 29) This header is for
connecting audio devices
to the front audio panel.
J_SENSE
OUT2_L
1
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to
connect them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel
and adjust “Recording Volume”.
1
In
Dummy
IntA_PB_D-
GND
IntA_
GND
IntA_PB_SSTX-
IntA_
IntA_PB_SSRX-
Vbus Vbus
Vbus
IntA_PA_SSRX-
IntA_
GND
IntA_PA_SSTX-
IntA_
GND
IntA_PA_D-
In
1
In Dummy IntA_PB_D- GN
D IntA_ GN
D IntA_PB_SSTX- IntA_ IntA_PB_SSRX- V
bus
V
bus
V
bus
IntA_P
A_SSRX-
IntA_P
GN
D
IntA_P
A_SSTX-
IntA_P
GN
D
IntA_P
A
_D-
IntA_P
A
_D+