ASROCK 890GMH/USB3, Быстрое руководство по установке

Страница: 22 / 79

2 2 2 2
2 2 2 2 2 2
ASRock 890GMH/USB3 Motherboard
EnglishEnglishEnglishEnglishEnglish
the red-striped side to Pin1
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 26)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 10)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These five Serial ATAII (SATAII)
(SATAII_1 (PORT 0):
connectors support SATAII
see p.2, No. 20)
or SATA hard disk for internal
(SATAII_2 (PORT 1):
storage devices. The current
see p.2, No. 19)
SATAII interface allows up to
(SATAII_3 (PORT 2):
3.0 Gb/s data transfer rate.
see p.2, No. 18)
(SATAII_4 (PORT 3):
see p.2, No. 17)
(SATAII_5 (PORT 4):
see p.2, No. 16)
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional)
SATAII hard disk or the SATAII
connector on the motherboard.
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
SATAII_1 SATAII_2 SATAII_3 SATAII_4 SATAII_5
(PORT 0) (PORT 1) (PORT 2) (PORT 3) (PORT 4)