ASROCK 4CORE1600-D800, Руководство по установке

Страница: 15 / 80

1 5 1 5 1 5 1 5 1 5
ASRock 4Core1600-D800 Motherboard
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100 cable
the red-striped side to Pin1
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional)
SATAII hard disk or the SATAII
connector on this motherboard.
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 20)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 7)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATAII_1: see p.2, No. 14)
connectors support SATA data
(SATAII_2: see p.2, No. 12)
cables for internal storage
(SATAII_3: see p.2, No. 13)
devices. The current SATAII
(SATAII_4: see p.2, No. 11)
interface allows up to 3.0 Gb/s
data transfer rate.
SATAII_3 SATAII_4
SATAII_1 SATAII_2
EnglishEnglishEnglishEnglishEnglish
Serial ATA (SATA) Please connect the black end of
Power Cable SATA power cable to the power
(Optional)
connector on each drive. Then
connect the white end of SATA
power cable to the power
connector of the power supply.
connect to
the power
connect to the SATA
HDD power connector