z
Alarm Types shown on Display:
1.
Indication of High-Pressure Alarm
: LED flashing on specific wheel with High-Pressure value
and “Beep” sound.
2.
Indication of Low-Pressure Alarm
: LED flashing on specific wheel with Low-Pressure value
and
“Beep”
sound.
3.
Indication of Sensor Low-Battery Warning
: Red Light on Power & LED on specific wheel on
display panel.
4.
Indication of Display Low-Battery Warning
: LED flashing indication on the Power light &
“Beep” sound.
z
Specification:
Sensors
LCD
Display
Dimension
ψ
22.3* H: 22.5
±0.5
(mm)
76mm (L) x 42.5mm (W) x 19.5mm (H)
Weight
10.0
g ± 0.5g ( w/Battery contained)
36.5g
± 0.5g (Battery Excluded)
Power Supply
3V Lithium CR1632
(1~2 year Lifetime or above 2 years when
under normal condition)
2 x 3A’ Battery Alkaline type or
(Power Supplied line 12V)
Frequency
433.92MHz 433.92MHz
Operating
Temperature
-30
℃
~ + 85
℃
-20
℃
~+80
℃
*Specification is subject to change for product performance without any notice
B. Installation
:
(Always have the display power on before installation of sensors)
Sensor Indication:
1.
Labeled w/
FL
: Front Left Wheel
2.
Labeled w/
FR
: Front Right Wheel
3.
Labeled w/
RL
: Rear Left Wheel.
4.
Labeled w/
RR
: Rear Right Wheel
Installation Process:
For Sensors:
1.
Make sure the top and bottom are tighten on the sensors
(Applied with enclosed wrench)
2. Remove the original valve from stem
。
3. Testing the pressure by applying Tire Gauges.(The suggested pressure value
can be referred to Car user manual to ensure proper pressure).
4. Screw-on the enclosed Hex nut on the valve; then, mount the valve
sensors onto the valve stem. Make sure the Hex nut is being tighten in reverse
clockwise direction to affix with the bottom part of the Valve Sensors
。
NOTICE
: To
Check the valve if it is leaking after installation
, it can be confirmed from the display to see if the
pressure has dropped down.
For LCD Display:
1.
Place the LCD display at best view place, then, have the
display power ON (or plugging DC12V supplied cord into cigarette part)
SUGGESTION: Make sure the display power is on to confirm the communication of sensor & display
is normal。
