Cleanup
311159A
7
Cleanup
1 Pump remaining material into
bucket until most of texture
material is out of hopper.
NOTE:
Keep a small amount of
air flowing through air line and
gun tip to prevent material from
backing up needle
2 Fill hopper with clean water.
3 Pump water through system
and out of gun.
4 Remove nozzle (4A) from gun
and allow water to flow
through and out of gun. Flush
until gun is clean.
WASTE
ti4290a
WATER
ti4334a
4A
5 Finish cleaning all compo-
nents. A soft brush may be
used to help loosen any dried
on material from surface.
Cleaning out all air passages
and components will improve
gun performance and life.
6 Connect air line to gun. Open
gun air valve (A), forcing air
through tip to clear out any
remaining material.
7 Disconnect air line and mate-
rial hose from gun.
To improve working condition for
future use, after cleaning apply
a few drops of light oil to:
•
air hose quick connect
•
material hose connections
•
trigger nut
•
air shutoff needle
•
material needle
FLUSH
ti4010a
ti4011a
A
ti4012a
