PAGE 7
User Manual WS 19 / March 2011 © ASL Intercom BV
.
9.1.2 Wireless Beltpack Settings
d. With the Channel Select switch at the rear
of the beltpack, select the TX/RX channel
according to the WS-200 or WS 400
setting.
e. Connect a headset to the beltpack and
insert fully charged batteries. When the
beltpack is switched on, a single short tone
should be heard and both LED
‟
s on the
front panel of the unit flash for half a
second. This indicates that the beltpack is
functioning properly.
f. When one pushes the CALL or the TALK
button, the LED
‟
s on the front panel are lit
and the green LED of corresponding
TX/RX module in the base station is lit.
It proofs the beltpack has connection with
the base station.
g. Turn down the OWN VOICE Volume
trimmer at the side panel of the beltpack
(counter-clockwise)
h. Set the volume control of the beltpack at
approximately 50%
i. Push the TALK button on the beltpack, talk
into the microphone and listen to your own
voice (you might hear a small delay in the
signal)
j. Adjust the side tone trimmer at the
referring TX/RX module in the base station
so that the level of your own voice is as low
as possible
k. Adjust the OWN VOICE trimmer on the
beltpack so that the level of your own voice
is to your liking.
9.2.
ASL WIRELESS CONNECTED TO A 4-WIRE INTERCOM SYSTEM
9.2.1 Base Station Settings
a. Give each TX/RX module in the base
station its own TX/RX channel by rotating
the „Channel select‟ switch.
Try to avoid TX/RX channels to be
physically next to each other, e.g. when
two WS-
400‟s are in your wireless system,
try to set them in this order: TX/RX
channels 2, 4, 6, 8, 1, 3, 5, 7. If one uses a
WS-200 with only two beltpacks, use
TX/RX channels 1 and 6
b. Make sure the interface mode switch at the
rear of the base station is set to “4
-
WIRE”
c. Connect the 4-wire intercom system via the
XLR-3 connectors at the rear panel of the
base station. Each XLR-3 male connector
(signal out) and female connector (signal
in) connects each TX/RX module to an
input/output of the a 4-wire intercom
system. The internal party line is now
disconnected.
9.2.2 Wireless Beltpack Settings
d. With the Channel Select switch at the rear
of the beltpack, select the TX/RX channel
according to the WS-200 or WS-400
setting.
e. Connect a headset to the beltpack and
insert fully charged batteries. When the
beltpack is switched on, a single short tone
s
hould be heard and both LED‟s on the
front panel of the unit flash for half a
second. This indicates that the beltpack is
functioning properly.
f. When one pushes the CALL or TALK
button, the LED‟s on the front panel are lit
and the green LED of the corresponding
TX/RX module in the base station is lit. It
proofs the beltpack has connection with
the base station.
g. Turn down the OWN VOICE Volume
trimmer at the side panel of the beltpack
(counter-clockwise)
h. Push the TALK button on the beltpack, talk
into the microphone and listen to your own
voice
i. Turn up the volume of your own voice by
adjusting the OWN VOICE trimmer to a
level that you like
