VAR8(EN54) and Variants – Installation Guide
U-0450-1818.doc – Issue: 01 complete, approved
Page 19 of 20
4
Safety and Precautions
Environmental
The temperature and humidity ranges shown in the
specifications for this product must not be exceeded.
This equipment must not be installed in an area that is
subject to a corrosive atmosphere, excessive moisture
or may allow water or other liquids to come into
contact with the unit or its external connections.
In the close proximity of some radio frequency
transmitters, the signal to noise ratio of this product
may be reduced. If this occurs, re-location of the
equipment or the signal cables is recommended.
ESD
This product contains static-sensitive devices. Observe
ESD precautions when working on the equipment with
the cover removed.
EMC
EMC compliance is dependent on this unit being wired
in accordance with these installation instructions.
Electrical Safety
!
!
Ensure power supply cabling is
adequately rated.
Always route power supply cabling away
from amplifier input cabling in the
equipment rack to reduce the risk of noise
pick-up.
!
!
Always replace blown fuses with the
correct type and rating.
Lithium Battery
!
!
This product contains a lithium battery.
Danger of explosion if battery is
incorrectly replaced.
Replace only with the same or equivalent
type.
Dispose of battery carefully to avoid
environmental damage.
Do not dispose of battery in a fire.
Unpacking and Handling
The equipment should be unpacked and inspected
immediately on receipt. If damage has occurred please
It is advisable to retain the original equipment packing
in the event that the equipment ever needs returning
for service.
Ensure that the name and address of the Authorised
Distributor from whom you purchased the unit is
recorded on the “Service and Warranty” page of this
manual for future reference.
Packing for Return for Repair
!
!
All electronics assemblies must be
properly packed in ESD protective
packing for transport, to prevent physical
and ESD damage.
!
!
The filler material used for packing for
return for repair must be antistatic or
static dissipative, as this may come into
contact with exposed connectors, wiring,
or PCB assemblies. The use of non-
conductive filler material may cause
damage to the electronic assemblies
reducing their operational life, or even
destroying them.
Advice on packing the product for return can be
provided by ASL.
