DANS01 – Installation Guide
Issue: 02 complete, approved
Page 11 of 12
4
Safety and Precautions
Environmental
The temperature and humidity ranges shown in the
specifications for this product must not be exceeded.
This equipment must not be installed in an area that is
subject to a corrosive atmosphere.
When installed in accordance to the instructions in this
document, the unit provides IP65 ingress protection.
ESD Precautions
This product contains static-sensitive devices. Observe
ESD precautions when working on the equipment with
the cover removed.
Electrical Safety
Always replace blown fuses in the supply to this
equipment with the correct type and rating. Ensure
power supply cabling is adequately rated.
Unpacking and Handling
The equipment should be unpacked and inspected
immediately on receipt. If damage has occurred please
advise your carrier or supplier.
!
!
This equipment contains electronic
devices that are sensitive to electrostatic
discharge. Please take precautions to
avoid damage to the electronics by static
electricity.
It is advisable to retain the original equipment packing
in the event that the equipment ever needs returning for
service.
Ensure that the name and address of the Authorised
Distributor from whom you purchased the unit is
recorded on the “
page of this
manual for future reference.
Packing for Return for Repair
!
!
All electronics assemblies must be
properly packed in ESD protective
packing for transport, to prevent physical
and ESD damage.
!
!
The filler material used for packing for
return for repair must be antistatic or
static dissipative, as this may come into
contact with exposed connectors, wiring,
or PCB assemblies. The use of non-
conductive filler material may cause
damage to the electronic assemblies
reducing their operational life, or even
destroying them.
Advice on packing the product for return can be
provided by ASL.
