How to connect electricity
Connect the appliance to the power mains using a connection cable. The wall outlet should be fitted
with a ground contact (safety socket). Nominal voltage and frequency are indicated on the rating
plate/label with basic information on the appliance.
The appliance must be connected to the power mains and grounded in compliance with the effective
standards and regulations. The appliance will withstand short-term deviations from the nominal
voltage, but not more than +/- 6%.
WARNING!
DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.
This provides the best performance and also prevents overloading house wiring circuits, which could
cause a fire hazard from overheated wires.
Never unplug your wine reserve by pulling on the power cord. Always grip plug firmly and pull straight
out from the outlet.
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do
not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the wine reserve away from the wall, be careful not to roll over or damage the power
cord.
Wine reserve location
Do not install the wine reserve where temperatures will be below 16°C
because it will not maintain
proper temperatures, and the wine reserve could develop high internal humidity.
For proper installation, the wine reserve must be placed on a level surface of hard material the same
height as the rest of the flooring. This surface should be strong enough to support a fully loaded
wine reserve, or approximately 500 kg each. See the Installation Instructions for complete directions.
Clearances
Allow 42,5 cm minimum clearance between the door and wall for a full 115° door swing. Allow 9 cm
min. clearance to a wall for a 90° door swing for Stainless Steel panel.
11
Installation and connection
