Asko FN22838S, Инструкция по эксплуатации

Страница: 13 / 20

13
Tools required: socket wrench No. 8, Phillips screwdriver, torx 25, fl at screwdriver
The procedure to change the direction of door opening should be carried out by at least two persons.
1. Remove the upper hinge cover (A) and the covering cap (G).
2. Undo the upper hinge (B) and remove the door (C) from the lower hinge (D).
3. Tilt the appliance backwards (make sure you do not press against the condenser unit on the rear wall of the
appliance as this may damage the cooling system), unscrew the lower hinge (D) and the foot (E), and move them to
the opposite side. Make sure the washer is installed like it was before disassembly.
4. Move the door hinges (F) to the opposite side, remove the door stopper S1 and attach the door stopper S2 supplied
in a bag with the instruction manual. Replace the door (C) back on the lower hinge (D).
5. Use the screws to attach the upper hinge (B) on the opposite side.
6. Replace the upper hinge cover (A) and the covering cap (G) on the opposite side.
7. Replace the handle (L): undo the side screws (M) and the (N) screw in the handle holder. Take care not to damage
the door. Pull the handle in the direction of the arrow Disassemble the handle (L): undo the screw (O), turn the
handle holder (P) by 180° and reattach it using the screw. On the opposite side of the door, remove the cover
plugs (R) and replace the handle (L) in the direction of the arrow 2. Reattach the handle using the screws (M) and (N).
Place the covering plugs/caps (R) on the opposite side of the door.
7
L
L
M
N
P
R
1
2
3
D
E
E
6
A
G
B
F
F
G
A
4
C
G
B
5
S1
S2
C
C
D
D
CHANGING THE DIRECTION OF DOOR OPENING