Asko DWC5916XXL, Руководство по эксплуатации

Страница: 21 / 28

Suggested machine installations
The dishwasher can be installed built-in, completely freestanding
or partially built-in.
A. Built-in
The dishwasher is intended for installation under a worktop. The
recess dimensions are illustrated. Holes for wires/cables need
not be larger than 38 mm in diameter. Make sure the edges of
such holes are even to prevent damage to the drainage and inlet
hoses and the power cable.
*Remove locking nuts for an installed height
of 860-861 mm.
[mm]
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip brackets.
This comprises two brackets, which are screwed into place as
illustrated.
The dishwasher is then pushed in so that the brackets engage
the rear feet. Now the dishwasher will not topple if pressure is
put on the open door. If the dishwasher is installed completely
on its own, side panels and a worktop must both be fitted.
Accessories can be purchased where you bought the dishwasher.
413
WARNING!
A completely freestanding dishwasher must be fitted with
anti-tip brackets.
C. Partially built-in
If the dishwasher is located so that one of its sides is visible, a
side panel must be fitted. Accessories can be purchased where
you bought the dishwasher.
Adjust the height and slide the
dishwasher into place
1 Start by measuring the height from the floor to the bottom
edge of the worktop.
2 Measure the height from the floor to the top edge of the
dishwasher.
3 Lean the dishwasher forwards a little and roughly adjust the
rear foot by turning the adjustment screw at the front clockwise
to raise and anticlockwise to lower the dishwasher (see
illustration below). Use a broad screwdriver or a socket
screwdriver.
4 Adjust the front feet by turning them clockwise to raise and
anticlockwise to lower the dishwasher.
24 mm
5 Check that there is an air gap of at least 3 mm between the
underside of the worktop and the top edge of the dishwasher.
6 Slide the dishwasher into place.
• Pull through the drainage and supply hoses when the
machine is slid into place.
• Check that the hoses have no kinks or sharp bends, and
check that there is nothing that can damage the hoses.
21