Asko DW20.1, Руководство по обслуживанию

Страница: 15 / 40

15
Connection to water
There must always be a stopcock in the supply
line. The stopcock must be positioned above the
sink or on the front edge of the sink unit.
The inlet pipe has a union with a 1/2” or 3/4”
internal thread, depending on the country.
When installation is complete, open the stopcock,
leave the system under pressure for a time and
check that all connections are tight.
Connection to electricity
A machine equipped with a flexible cord and a plug
must be connected to an earthed electrical socket.
Technical data
See rating plate on the right-hand side of the door.
WARNING!
The flexible cord must be disconnected or the
electrical socket must be dead when working on
the machine!
Figure 3.
I N S T I N S T
I N S T I N S T
I N S TA L L A A L L A
A L L A A L L A
A L L AT I O N T I O N
T I O N T I O N
T I O N
Max 3 m
Min 16 mm
M
in 350 mm
Max 950 mm
Holder hose
Connection to drain
• Route the drain hose to a connection nipple on
the water trap of the sink. Note that the hose must
be secured on a level with the under side of the
sink, as washing water from the sink can
otherwise run down into the dishwasher (see
Figure 3).
• Fit the drain hose onto a cone-shaped pipe
connection on the water trap of the sink. The
cone-shaped pipe must be cut to an internal
diameter of at least 16 mm (see Figure 3).
• The drain hose may be extended up to a maxi-
mum of 3 m. Any connectors and connecting pipes
must have an internal diameter of at least 16 mm.
No part of the drain hose may lie higher than 950
mm above the floor (see Figure 3).
• The hose must not be taken directly to a floor
drain or similar. In this case the hose can function
as a siphon which suck water out of the machine.
• The hose must always discharge at least 350
mm above the floor (see Figure 3).
• Connect the Hose holder.
(Min 350 mm - max 950 mm above the floor.