Action
Possible causes
Problem
Clean the coarse and fine filters.
The filters are blocked.
Water remains in the
dishwasher.
Check that the filter handle is
locked in the stop position.
The filters are not fitted correctly.
Clean the drainage pump. See
the chapter Care and cleaning.
Debris in the drainage pump.
Check that the coloured stop on
the right in the bottom drain is in
place. See the chapter Care and
cleaning.
Drainage pump stop missing.
Check that the hose is free from
kinks and sharp bends.
Kink in drainage hose.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner
diameter of at least 14 mm.
Blocked drainage hose.
Clean with washing-up brush
and low foaming cleaner.
Dirt around the seals and in
corners.
Bad odour in dishwasher.
Run a program with a high
temperature once or twice a
month.
Low temperature programs have
been selected for a prolonged
period.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as
Intensive.
Low temperature programs have
been selected for a prolonged
period.
Grease deposits in the
dishwasher.
Activate the Auto Open option.
The Auto Open option is not
activated.
The dishes are not dry enough.
Fully load the dishwasher.
The dishwasher is not fully
loaded.
Top up with rinse aid or increase
the rinse aid dosage level. See
the chapter Settings.
Rinse aid needs topping up or
dosage is set too low.
Switch all-in-one detergents or
deactivate the setting TAB and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.
The setting TAB is activated and
all-in-one detergent with
insufficient drying effect is being
used.
Table continued from last page
34
Troubleshooting
