Action
Possible causes
Problem
Clean the coarse and fine filters.
The filters are blocked.
Water remains in the dishwasher.
Check that the filter handle is locked in the stop
position. The handle should point towards the
back of the dishwasher.
The filters are not fitted correctly.
Clean the drainage pump. See the chapter Care
and cleaning.
Debris in the drainage pump.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning.
Drainage pump stop missing.
Check that the hose is free from kinks and sharp
bends.
Kink in drainage hose.
Disconnect the drainage hose where it connects
to the sink unit's water trap. Check that no debris
has fastened and that the connection has an
inner diameter of at least 14 mm.
Blocked drainage hose.
Clean with washing-up brush and low foaming
cleaner.
Dirt around the seals and in corners.
Bad odour in dishwasher.
Run a program with a higher temperature once
or twice a month. Or run a self-cleaning
program. See Self-cleaning in Chapter Using
the dishwasher.
Low temperature programs have been selected
for a prolonged period.
Run a self-cleaning programme. See
Self-cleaning in the chapter Using the
dishwasher.
The dishwasher has not been used for a while.
Activate the Extra Dry option.
Depending on the load, the programme's drying
cycle may be insufficient.
The dishes are not dry enough.
Fully load the dishwasher.
The dishwasher is not fully loaded.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Rinse aid needs topping up or dosage is set too
low.
Open the door a little once the program has
finished.
19
