Asko DFI643AU, Руководство по эксплуатации

Страница: 16 / 24

Troubleshooting
Action Type of fault on the display
Clear the drainage pump. See the chapter Care and cleaning. If the problem persists, call the
service department.
Overfilling water 1 F10
See “Water remains in the dishwasher” in the table “Problem” below. If the problem persists, call
the service department.
Water outlet fault F11
Check whether dishwasher inlet hose is connected to a pressure limiting valve (some pressure
limiting valves may restrict the supply of water to the dishwasher).
Water inlet fault F12
Check that the water tap is on. Check that the outer filter on the inlet hose is not blocked. See
Unblocking the inlet hose filter in the chapter Care and cleaning. If the problem persists, call for
service.
Check that the water tap is on. If the problem persists, call the service department.
Turn off the water tap and call the service department. Inlet valve leakage F40
Call the service department. Water level fault F52
Turn off the water tap and call the service department. Overfilling water 2 F54
Call the service department. Circ. pump fault F56
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons too soon after
opening the door.
The buttons do not react when pressed.
See the chapter Settings. Child lock (button lock) activated.
Open the door. The buttons only react to use
when the door is open.
The door is closed.
Clean with a dry or slightly damp cloth. The buttons are dirty.
Check that the baskets are correctly positioned
horizontally.
The baskets are not correctly positioned. Cannot close door.
Check that the dishes are not blocking the bas-
kets from sliding properly into place.
Press and hold Start/Stop until the display shows
"Program started, close door".
The Start/Stop start button has not been pressed
for long enough.
The dishwasher does not start.
Check. The door is not properly closed.
Close the door and wait. After a while, the dish-
washer continues the program.
You have opened the dishwasher to add more
dishes while a program is in progress.
Check. A fuse/circuit breaker has been tripped.
Check. The plug is not plugged into the wall socket.
Check. The water tap is turned off.
Check. Overflow/leaks
Turn off the water tap. Pull out the plug and call
the service department.
A whirring sound (the drainage pump) is heard
from the dishwasher and does not stop when the
main power switch is turned off.
Press and hold Start/Stop for three seconds if
you want to cancel the Delayed Start option.
Check that the Delayed Start option has not been
selected.
16