Asko DBI664, Руководство по эксплуатации

Страница: 21 / 28

Placing the dishwasher
The dishwasher is intended to be built in under a countertop. The
built-in measurements are shown in the illustration. Make sure that the
cord and hose hole's edges are even and will not damage the drain
and inlet hoses or the power cord.
24
5 3/8
2
4
24
34
3/8* - 36 1/2
['']
The electrical and
water supplies should
enter through the area
indicated by the
shading on the
illustration.
*33 7/8'': Remove the trim kit.
NOTE!
Framed cabinets require additional finished filler material behind the
face frame for a proper installation. A minimum 3½” (89 mm) finished
return is required on all sides of the opening.
3½”
¾”
3½”
Frameless
cabinetry
Filler
Framed
cabinetry
If the dishwasher is built-in, the surrounding furnishings must be
resistant to any condensation from the dishwasher.
Fit the protective film
Fit the protective film (packed in the document bag) to the underside
of the countertop. The protective film is to protect the countertop from
moisture.
NOTE!
The surface to which the protective film is fitted must be clean and
dry.
Adjust the height and slide the
dishwasher into place
1. Start by measuring the height from the floor to the bottom edge of
the countertop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Lean the dishwasher forward a little and adjust the rear foot with
the screw at the front of the dishwasher. Turn clockwise to lower or
counterclockwise to raise.
4.
Max 0.4 Nm
5. Adjust the front feet by turning them clockwise to raise and
counterclockwise to lower the dishwasher.
2x
1''
5/8''
6. Verify there is an air gap of at least 1/8'' between the underside of
the countertop and the top edge of the dishwasher.
7. Slide the dishwasher into place.
• Pull the drain and supply hoses through the opening as the
dishwasher is slid into place.
• Check that the hoses have no kinks or sharp bends, and check
that there is nothing that can damage the hoses.
8. Make any final adjustments to the feet (the dishwasher may lean
no more than 1/4'') and tighten the lock nuts on the front feet.
21