Asko DBI663 SSOF, Руководство по эксплуатации

Страница: 18 / 28

Action Possible causes Problem
Check that the dishes are not blocking the spray
arms. The spray arms do not rotate. The dishes are not clean.
Clean the spray arms. See the chapter Care and
maintenance instructions.
Spray arm holes or bearings blocked.
Choose a longer program. Unsuitable dishwashing program.
Dose according to water hardness. Far too much
or far too little detergent can result in poor
dishwashing results.
Incorrect detergent dosage.
Avoid large packages. Detergent is too old. Detergent is a perishable
product.
Do not cover dishes with large bowls or lids.
Avoid placing very tall glasses in the corners of
the baskets. Dishes loaded incorrectly.
Load the dishes securely. Glasses and cups have toppled over during the
program.
Check that the filter handle is locked in the stop
position. The handle should point straight out
from the dishwasher.
The filters are not fitted correctly.
Rinse off these types of food if not starting the
dishwasher immediately. Use the Rinse and hold
program.
Some types of food, such as mustard,
mayonnaise, lemon, vinegar, salt, and dressings,
can mark stainless steel if left for too long.
Spots on stainless steel or silver.
In order to avoid marks and tarnishing, separate
dishes made from different metals, such as silver,
stainless steel, and aluminum.
All stainless steel can cause spots on silver if
they come into contact during dishwashing.
Aluminum can also cause spots on dishes.
See the chapter Settings. Incorrect rinse aid dosage setting. Spots or films on the dishes.
Switch all-in-one detergents or deactivate the
TAB setting and top up with salt and separate
rinse aid. See Rinse aid in the chapter Settings.
The TAB setting is activated and all-in-one
detergent with insufficient drying effect is being
used.
Top up with salt. See the chapter Before washing
for the first time. Salt compartment empty.
See Water hardness in the chapter Settings. Incorrect water softener setting.
Check that the salt compartment lid is properly
tightened. Otherwise call the Customer Care
Center.
The water softener is leaking salt.
Wash crystal at a low temperature and with a
conservative amount of detergent. Contact the
detergent manufacturer.
Too high temperature and/or too much detergent
can cause etching on crystal. Unfortunately, this
cannot be repaired, only prevented.
Reduce the dosage. See the chapter Settings.
If you have very soft water, you may want to dilute
the rinse aid 50:50 with water.
Rinse aid dosage setting too high. The dishes have a sticky white/blue film.
Use a detergent with a bleaching agent. Lipstick and tea can be difficult to wash off. Spots left after washing.
The detergent compartment must be dry when
adding detergent.
The detergent compartment was damp when
adding detergent.
Detergent residue in the detergent compartment
after dishwashing.
Check that the dishes are not preventing the
detergent compartment from opening.
The detergent compartment has been blocked.
Check that the dishes are placed securely. Spin
the spray arms to make sure they can rotate.
The dishes are not correctly placed or the spray
arms are not rotating.
Rattling sound when dishwashing.
18