Asko D5896XXLFI, Руководство по эксплуатации

Страница: 17 / 28

Action Possible causes Problem
Check that the salt compartment lid is
properly tightened. Otherwise call the service
department.
The water softener is leaking salt. Spots or films on the dishes.
See the section Settings. Incorrect water softener setting.
See the sections Before washing for the first
time and Settings.
Incorrect rinse aid dosage setting.
Top up with salt. See the section Before
washing for the first time.
Salt compartment empty.
Inactivate the setting TAB (3-in-1/ All-in-one
detergent) and top up salt and rinse aid.
3-in-1/ All-in-one detergent is used and the
setting TAB (3-in-1/ All-in-one detergent) is
activated.
Wash crystal at a low temperature and with
a conservative amount of detergent. Contact
the detergent manufacturer.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired, only
prevented.
Reduce the amount. See the sections Before
washing for the first time and Settings. If you
have very soft water, you may want to dilute
the rinse aid 50:50 with water.
Rinse aid dosage setting too high. The dishes have a sticky white/blue film.
Rinse off these types of foodstuffs if not
starting the dishwasher immediately. Why
not use the Rinse programme.
Some foodstuffs, such as mustard,
mayonnaise, lemon, vinegar, salt and
dressings, can mark stainless steel if left for
too long.
Spots on stainless steel or silver.
Silver and stainless steel items should not
come into contact during dishwashing.
All stainless steel can cause spots on silver
if they come into contact during dishwashing.
Aluminium can also cause spots on dishes.
Use a detergent with a bleaching agent. Lipstick and tea can be difficult to wash off. Spots left after washing.
Check that the dishes are placed securely.
Spin the spray arms to make sure they can
rotate.
The dishes are not correctly placed or the
spray arms are not rotating.
Rattling sound when dishwashing.
Press and hold Start/Stop until the display
shows "Program started".
The Start/Stop start button has been pressed
for too short a time.
The dishwasher does not start.
Check. The door is not properly closed.
Check. A fuse/circuit breaker has been tripped.
Check. The plug is not plugged into the wall socket.
Check. The water tap is turned off.
Check. Overflow/leaks.
Turn off the water tap. Pull out the plug and
call the service department.
A whirring sound (the drainage pump) is
heard from the dishwasher and does not stop
when the main power switch is turned off.
Press and hold Start/Stop for three seconds
if you want to cancel the Delayed start option.
Check that the Delayed start option has not
been selected.
17