Asko D5132, Инструкция по использованию и уходу

Страница: 32 / 36

Installation
Positioning the machine
A. Adjusting freestanding dishwashers
1. Adjust the height of the dishwasher with the
four steel feet.
2. Lock the feet with the nuts.
B. Adjusting machines with three or four
feet
1. Start by measuring the height from the floor
to the underside of the work top of your kit­
chen bench.
2. Install the sliding feet on the dishwasher.
3. Measure the height from the floor to the top
edge of the dishwasher.
4. Adjust all the feet by screwing them clock­
wise to raise or anti­clockwise to lower.
5. Check that the height of the machine cor­
responds to the height from the floor to the
underside of the work surface. Tighten the
locking nuts (locking nut) on the rear feet.
6. Push the dishwasher into place.
7. Finely adjust the front feet and tighten the
locking nuts.
C. Adjusting machines with adjustable
feet
1. Start by measuring the height from the floor
to the underside of the work surface.
2. Install the sliding feet on the dishwasher.
3. Measure the height from the floor to the top
edge of the dishwasher.
4. Tilt the dishwasher forward a fraction and
roughly adjust the rear foot by screwing the
set screw at the front clockwise to raise or
anti­clockwise to lower (illustrated below).
Use a broad screwdriver or a hexagonal
head screwdriver.
5. Adjust the front feet by turning them clock­
wise to raise or anti­clockwise to lower.
6. Check that the height of the machine cor­
responds to the height from the floor to the
underside of the work surface.
7. Push the dishwasher into place.
8. Finely adjust the feet (the machine may lean
max. 5 mm) and tighten the locking nuts on
the front feet.
3. After the steel feet have been adjusted,
screw down the two rubber feet tightly
against the floor.
The rubber feet now work as anti­tilt protection.
Steel feet
Stålfötter