Page
Customer Care Center
1-800-898-1879
www.askousa.com
TOOLS
1)
Phillips No. screwdriver
)
Flat blade screwdriver
3)
Torx screwdriver size T 0
4)
Adjustable wrenches (if you use copper fittings)
5)
Open-ended wrench (1/” [1 mm] or 5/8” [16
mm])
6)
Tape measure
7)
Spirit level
8)
Electric drill with
1-
5/8”
drill bit
9)
Keyhole saw
MATERIALS
♦
Minimum 3/8" OD copper tubing of sufficient length
for your installation
♦ S
hut-off valve and fittings for water supply line
Tip Guards (optional)
When it is not possible to attach the dishwasher to the
cabinet or the underside of the cabinet top, you should
install tip guards to prevent the machine from tipping
when you open the door.
Refer to page 7 for installation instructions.
Technical Data
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
If a dishwasher is being installed in this area for the first
time, most of the cabinet work, plumbing, and electrical
has to be done before you move the machine into
place.
NOTE: Cosmetic damage must be reported to
the ASKO dealer within five days from the date of
purchase. As soon as you unpack the dishwasher,
thoroughly check it for cosmetic damage.
If you are replacing an old dishwasher, you must check
the plumbing connection and wiring before you move the
new dishwasher into place.
Tip Guards
(P/N 8070851)
INTRODUCTION
WHAT YOU NEED
The dishwasher is shipped with the high loop drain
hose, inlet hose and electrical cord attached and ready
to be connected.
Please do not remove the high loop
connection for the drain line.
Electricity
120V, 60Hz, 15 amp
Water pressure:
4.2-140 psi,
0.03-1.0 MPa,
0.3-10 Bar
Heating element:
1200 watt
Max loading
1300 watt
